TeamSwift
http://www.teamswift.net/

Whiteline Pan Hard Bushings
http://www.teamswift.net/viewtopic.php?f=10&t=61194
Page 1 of 1

Author:  Solerpower [ Sun Jan 10, 2016 9:46 am ]
Post subject:  Whiteline Pan Hard Bushings

These are the pan hard bushings from Whiteline below. If you have installed these please let me know how they fit. I believe these go into the bottom of the rear knuckle where the rear control arm goes around. I could not think of a good way to press these out. I will have to cut the inner race and then torch them with a acetylene torch. I lined them up with the rear knuckle and the width is good although they will end of having a forward tab where the oem ones don't have that tab on outside, however the diameter is questionable because there appears to be an outer metal race on the oem ones. I orginally thought they went to the rear tie rod, but I could not see how they would work for that. The inner race of the barrel was right, but nothing else was. I will check one more time, and if no one answers I will experiment with a spare Geo Metro rear knuckle to see how it fits.

Image
Image
Image
Image

Author:  Solerpower [ Sun Dec 04, 2016 12:54 pm ]
Post subject:  Re: Whiteline Pan Hard Bushings

I hate to leave a post not answered. I answered this post myself on the sticky for poly-bushings linked below. That way it keeps the information in one place.

viewtopic.php?f=10&t=1230

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/