TeamSwift
http://www.teamswift.net/

Front control arm forward bushing replacement.
http://www.teamswift.net/viewtopic.php?f=10&t=62177
Page 1 of 1

Author:  SWIFTDOOG [ Tue Dec 13, 2016 8:21 am ]
Post subject:  Front control arm forward bushing replacement.

Good morning all.

Straight to the point. I am unable to find that forward bushing of the front control arm. (Of course, if I had $$$ I would buy it online, obviously but since living in socialism then... you know).
http://www.moog-suspension-parts.com/moog-k200312 Image

The help I need from you guys is the following:

* Dimensions or measurements of the bushing, or...
* What other car (besides the obvious geo metro, sprint, firefly, or any swift / metro clones) uses something that matches the inner diameter of the bushing and the lenght. Doesn´t matter if the rubber part is wider, I can cut and custom fit anyways.[/list]

For example, the Geo Prizm (or Toyota Corolla) seems to use something quite close, but I will go out (once again) to the parts stores around to see if they match. Image

Thanks

Author:  Teeth [ Wed Dec 14, 2016 4:39 pm ]
Post subject:  Re: Front control arm forward bushing replacement.

This should help.

This is for Whiteline's aftermarket bushing that has a different design, but the dimensions are there. Also, whiteline cross references this part with a Subaru XT, which is just about as obscure, but maybe you could try that route.

Image

Author:  Teeth [ Wed Dec 14, 2016 4:45 pm ]
Post subject:  Re: Front control arm forward bushing replacement.

Whoops, I see you are looking for a part to fit 1995-2000, so that might not be right.

Author:  suzukitom [ Wed Dec 14, 2016 5:40 pm ]
Post subject:  Re: Front control arm forward bushing replacement.

Teeth wrote:
Whoops, I see you are looking for a part to fit 1995-2000, so that might not be right.


OP is from Venezuela so the Swift version is same as mk3

Author:  Teeth [ Thu Dec 15, 2016 2:17 am ]
Post subject:  Re: Front control arm forward bushing replacement.

Ah, well then, the link he posted is for the wrong part =)

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/