TeamSwift
http://www.teamswift.net/

Rack & pinion dimensions needed!
http://www.teamswift.net/viewtopic.php?f=10&t=62259
Page 1 of 1

Author:  n1tr0 [ Wed Jan 18, 2017 11:27 pm ]
Post subject:  Rack & pinion dimensions needed!

I'm looking for someone who has easy access to measuring their rack. I'm hoping the Swift (GT) rack matches my current project. Looking for about 62.5cm from center of the balls (center of the pivot points) that the tie rods pivot around.
Thanks
eg.
Image

Author:  Dattman [ Thu Jan 19, 2017 1:49 am ]
Post subject:  Re: Rack & pinion dimensions needed!

Hey Kris, welcome back 8) you're a week too late for me to help you, just put my engine and box back in the race car on Sunday, hopefully someone else can chip in.

Can you tell us what the project is or is it for a customer? it looks a lot like an AE86/MR2 rack.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/