TeamSwift
http://www.teamswift.net/

200/335 210/340 cams (hybrid). dyno sheets added
http://www.teamswift.net/viewtopic.php?f=11&t=58548
Page 1 of 1

Author:  ng357 [ Fri Jul 11, 2014 10:01 pm ]
Post subject:  200/335 210/340 cams (hybrid). dyno sheets added

Does anyone have a dyno sheet showing these cams with stock pistons? I have them currently but have not installed them yet only because I am still a bit skeptical of loosing low end power. As I have heard a few people said they did not loose any low end power but if I could see a dyno sheet that would be great.

I have dyno sheets of my fairly stock motor and will be getting some done soon with my newly acquired chips from 'teeth'. After I install my set of cams I will run on the dyno again for some of you guys to benefit!

Author:  ng357 [ Mon Aug 25, 2014 9:54 pm ]
Post subject:  Re: 200/335 210/340 cams (hybrid)

Well I ended up purchasing the cams setups and doing the dyno runs for the benefit of Teamswift members.

Run 2 is with the hybrid cam
Run 7 is with the stock cam

Attachments:
Stock cam vs Hybrid cam.mn.jpg
Stock cam vs Hybrid cam.mn.jpg [ 99.35 KIB | Viewed 1724 times ]

Author:  PBC137 [ Fri Aug 29, 2014 12:10 am ]
Post subject:  Re: 200/335 210/340 cams (hybrid). dyno sheets added

Nice plots there bro! Maybe you should also post your mods.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/