TeamSwift
http://www.teamswift.net/

Steel Buss Bar
http://www.teamswift.net/viewtopic.php?f=12&t=61828
Page 1 of 1

Author:  CMA [ Mon Jul 25, 2016 1:49 pm ]
Post subject:  Steel Buss Bar

Is it safety to remove?

I know it's supporting the dashboard wiring, and ground point.

It only supported by little 4 screws so I wonder if it's part of safety equipment. :?

Author:  suzukitom [ Mon Jul 25, 2016 3:15 pm ]
Post subject:  Re: Steel Buss Bar

Are you thinking about removing the horizontal steel dashboard support beam (shown in Lihtan's build thread picture below)?

Why would you want to do remove it? Yes it does support the dashboard cover and provide some ground connections, but it does not weigh very much.

Image

Author:  suzukitom [ Mon Jul 25, 2016 5:38 pm ]
Post subject:  Re: Steel Buss Bar

http://www.teamswift.net/viewtopic.php?f=12&t=16675&hilit=lihtan+dashboard+brace

Hey, you were part of this post 11 years ago! :D

Author:  CMA [ Mon Jul 25, 2016 6:29 pm ]
Post subject:  Re: Steel Buss Bar

Yes that's what I meant. I felt it's bit ugly and too thick.


This picture what I want... It looks so nice... but I will might need to keep the bottom half of dashboard tho.
Image
http://www.redlinegti.com/forum/viewtop ... 5&start=40

PS. Honestly I don't remember and I was so noobie.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/