TeamSwift
http://www.teamswift.net/

Distributor rebuilds by Fainya
http://www.teamswift.net/viewtopic.php?f=17&t=56296
Page 1 of 1

Author:  fainya [ Wed Jun 12, 2013 9:36 pm ]
Post subject:  Distributor rebuilds by Fainya

Thank you everyone who has sent me a distributor to build.
I rebuild distributors for TeamSwift members.
This service is offered on distributors that you send me.

ODB1 and ODB2 distributors.
New main shaft Class 3 bearing, directional seal, outer body o ring,
glass bead housing, reset airgap, replace screws as needed.
Air gap set on pickup coil.
$40 + $10 shipping.
Electronics are checked, and replaced at additional cost if needed.

Pre ODB1 distributors
These have vacuum advance, and mechanical advance.
90% of these are rebuildable. The time it takes to do these drives the cost up.
New main shaft class 3 bearing, seal, outer o ring, advance springs, free up
vacuum advance plate bearing. Glass bead housing, replace screws as needed,
cap clips, outer screws, are de-rusted and parkerized to prevent further decay of the parts.
Dark gray color on the parkerized parts.
I will recurve the mechanical advance because of the springs being replaced.
Air gap set on pickup.
$90 + $10 shipping
Electronics are checked. If the electronics are bad I will replace them at an additional cost.
Vacuum advance units are checked. If they are bad I can replace them at an addtional cost

Warrenty is for one year on workmanship and replaced parts.
I do not warrenty bad installations.
PM me for shipping information, and turn around times.

Author:  t3 ragtop [ Thu Jun 20, 2013 5:43 pm ]
Post subject:  Re: Distributor rebuilds by Fainya

a man of many talents, fainya also produces lead mallets which are a "must have" tool in your kit.

real lead mallets are hard to come by these days but damn! they're handy. they provide a true "dead blow" and don't mark steel parts when you smack them into submission. :twisted:

Author:  Prairie to Pine Co. [ Thu Jun 20, 2013 8:46 pm ]
Post subject:  Re: Distributor rebuilds by Fainya

They work great on noisy teenagers and politicians too. :lol: :lol: :lol:

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/