TeamSwift

Home of the Suzuki mini-compacts ! Your Home for all things Suzuki Swift, Geo Metro, Holden Barina, Chevy Sprint, Pontiac Firefly, and Suzuki Cultus. TeamSwift is a technical performance oriented community!
It is currently Sat Oct 21, 2017 11:27 pm

Underbody braces, turbos and more!

All times are UTC - 5 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Replacing A/C Compressor
PostPosted: Fri Apr 06, 2012 5:36 am 
Offline

Joined: Tue Oct 03, 2006 10:43 pm
Posts: 720
Location: Texas 75150
What Should I use to flush out the A/C components with?
What is the best oil to use in the A/C system?
This last winter I had the A/C clutch bearing get so bad I had to disconnect the drive belt.
With close to 200K on the original compressor and random A/C issues over the past 7 years, I have decided to replace the A/C compressor, expansion valve, and dryer. The guy that worked on this car before me used a lot of green dye leak checking crap in this system. So I want to flush out the entire system before installing the new compressor. The evaporator will be coming out too, to replace the expansion valve.
I helped a friend of mine replace all of his blend door foam when he installed A/C in his 94 Geo. He also added window screen behind the air intake trim panel below the windshield. I am sure there is going to be a lot of crap inside the blower motor housing and the evaporator housing just like my friends car had. So I will be adding a screen to mine too. I will refoam the doors as needed.

_________________
Fainya
97 Geo Metro LSI,1.3L-GT-DOHC-16v,4.10 5-speed,A/C,170,000,suspension lowered 1",4 wheel disk brakes,15"alloy wheels with 185/50-15 Toyo's,GT bucket seats,analog oil pressure gauge,cruise control, new paint job. 40 mpg at 65 mph.
Good, fast, cheap. You only get two.


Top
 Profile  
 
PostPosted: Fri Apr 06, 2012 6:43 am 
Offline

Joined: Tue Oct 19, 2010 9:16 am
Posts: 412
Location: sidney, nebraska
You would want to use ans actual A/C system flush solvent availible at most auto parts stores. its compatible with the materials in the system and has a minimal chance of causing corrosion in the system later on. The solvent gets "blown" thru the system with a special pressure chamber with compressed air. If your installing a new compressor then you need to use either pag or ester oil which ever the manufacture recommends to maintain warrenty. Be sure to replace all the o-rings in the system with R-134a compatible parts or all your work will be in vain.

_________________
"If you think education is expensive, try ignorance." - Derek Bok


1990 geo metro 1.0 5 speed 3-door hatchback "herbie"
1990 geo metro 1.0 5 speed convertible "sportie"


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group