|Page 1 of 1|
|Author:||sgr16v [ Wed Jan 25, 2017 1:57 pm ]|
|Post subject:||Timing Problem|
I'm up to a timing problem for now.I installed a BD Chip mk3 and tried to adjust the timing to 4 degrees as requested.I wired the two monitor coupler pins D-E as manual described but i could not get a steady mark.It jumps up and down..What else should i do?
I have a MSD 8207 MSD Blaster SS Coil,a 323 GTX distributor cap(a samurai swap) and an Intake camshaft gear to EX position.
|Page 1 of 1||All times are UTC - 5 hours|
|Powered by phpBB® Forum Software © phpBB Group