TeamSwift
http://www.teamswift.net/

G10 NA Megasquirt MS1 V3
http://www.teamswift.net/viewtopic.php?f=5&t=61577
Page 1 of 1

Author:  TR63 [ Mon Apr 18, 2016 2:21 pm ]
Post subject:  G10 NA Megasquirt MS1 V3

Hello from Germany,
Sorry, if i have some mistakes in my writing :D
My problem:
I am new in the Suzuki G10 engine.
I have built a Megasquirt (MS1 V3) for this engine.

It already runs :D

But i am not sure with my Ignition Advance Main Table:
Attachment:
g10 NA ignition advance table.png
g10 NA ignition advance table.png [ 269.71 KIB | Viewed 1094 times ]



I have no knocking tool.

Is there any advice here?

Thank you so much
Regards

Author:  t3 ragtop [ Mon Apr 18, 2016 5:25 pm ]
Post subject:  Re: G10 NA Megasquirt MS1 V3

46 degrees of total advance looks a little hot to me.

i recommend the knocksenseMS knock sensor. it uses a bosch sensor and was developed for volvo turbo brick use. the filter it's based on works fine on my turbo3/ g10t and megasquirt2. the unit turns on an ultra bright green led and sends a signal to the megasquirt to retard ignition at what ever rate you program in.

Author:  7113 [ Sat Apr 23, 2016 9:51 am ]
Post subject:  Re: G10 NA Megasquirt MS1 V3

This is very interesting. Could you post pictures of your other tables?
I agree with t3 ragtop although running race engines at that advance is not that extreme.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/