TeamSwift
http://www.teamswift.net/

'92 Metro Crankshaft query
http://www.teamswift.net/viewtopic.php?f=5&t=61617
Page 1 of 1

Author:  Cell Damage [ Sat Apr 30, 2016 3:59 pm ]
Post subject:  '92 Metro Crankshaft query

So....
Standard Crankshaft should measure 1.7710 inches, right?
My number 3 is measuring out to 1.5885 in. with a difference of 0.1825 in. between the two measurements.

My question is; should I use a bearing that is 20k over? Or will a 10k over be sufficient?

Thanks for any replies.

Edit:

On a side note, what procedures are necessary to paint the plastic bumpers? I'd like to paint them to match the rest of the car someday.

Author:  Cell Damage [ Sat Apr 30, 2016 6:20 pm ]
Post subject:  Re: '92 Metro Crankshaft query

Nevermind. The crankshaft is out of round and I just tried the biggest bearings they make for it. Time for a new crankshaft.

Author:  Peenutzz [ Tue May 10, 2016 2:26 pm ]
Post subject:  Re: '92 Metro Crankshaft query

Sorry about that crank, good luck with that.

I painted my bumpers years ago, they were plastic, now they are Motip Matt Black. I simply sanded them with pretty coarse sandpaper, after that I gave them a wash with water and soap and a scotchbrite pad, rinsed them clean, let them dry and wiped them once with a cloth of thinner just to be sure. Then I applied two coats (I think, it's pretty hard to see where you've been already) of Motip Plastic primer and two coats of matt black. Still holds, almost 6 years later.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/