|How to make MS EDIS trigger wheel?
|Page 2 of 2|
|Author:||miniswift [ Fri May 06, 2016 3:39 pm ]|
|Post subject:||Re: How to make MS EDIS trigger wheel?|
Well these are what I have and starting to make bit more little by little.
I think Adaptronics are actually MS derived ECU?
3Bar MAP and other stuff so I hope it will be OK.
I will be making 1 more engine block just in case my block guard engine goes bang!
|Page 2 of 2||All times are UTC - 5 hours|
|Powered by phpBB® Forum Software © phpBB Group