TeamSwift
http://www.teamswift.net/

G13b oversize piston in a g16 block
http://www.teamswift.net/viewtopic.php?f=7&t=56073
Page 1 of 1

Author:  Swiftgti92 [ Thu May 09, 2013 8:41 am ]
Post subject:  G13b oversize piston in a g16 block

I'm rebuilding a engine that is a 1.6 Dohc conversion (all stock) got 106 hp at the wheel and would like to increase this with rebuild , heads getting worked crank and fly wheel lightned and balanced and I'm tethering with the idea to use the g13 piston with the g 16 rod and crank to bring up the compression ratio .ive searched the site and found the d series pistons are the go but just want to try something a bit different ,if anyone has any ideas or has done this please message me thanks kris .

Author:  Xprey [ Fri Aug 09, 2013 9:47 pm ]
Post subject:  Re: G13b oversize piston in a g16 block

Hi, if you use those pistons you are going 12.5 cr more or less, honda p29 pistons will raise to 14.0 cr what is to much but have been done allready

Author:  elbola [ Fri Aug 09, 2013 10:06 pm ]
Post subject:  Re: G13b oversize piston in a g16 block

About P-29 pistons... viewtopic.php?f=4&t=56091. That was on the G13b block though

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/