TeamSwift
http://www.teamswift.net/

1.6 16v swap
http://www.teamswift.net/viewtopic.php?f=7&t=59369
Page 1 of 1

Author:  sledgehammer [ Thu Nov 20, 2014 4:01 pm ]
Post subject:  1.6 16v swap

G16 on g13 transaxle. Just lowered it in last night. More later.

Image

Author:  elbola [ Thu Nov 20, 2014 5:04 pm ]
Post subject:  Re: 1.6 16v swap

I've read that you need an adapter plate to use the G16 trans on G13 engines. You are doing the oposite, but I don't see a plate. Could you provide more details on whats going on here?

Author:  G16B_Sedan [ Mon Nov 24, 2014 7:27 pm ]
Post subject:  Re: 1.6 16v swap

jus enlarge the two upper holes and you drill the block for the two lower holes and use a nut ant bolt. been doing it that way for years, with no issues even had a gti box on my J18 in latter stages.

Author:  me and my metro [ Mon Nov 24, 2014 9:58 pm ]
Post subject:  Re: 1.6 16v swap

You must have to use the 1.3 flywheel. What flywheel fits the small bell housing with th j18? They do make a large bell housing for the rod shifted tranny, they come in a g16 Esteem.

Author:  G16B_Sedan [ Sun Nov 30, 2014 12:16 pm ]
Post subject:  Re: 1.6 16v swap

j18 flywheel was cut down n use gti/gs ring gear. j18 has 8 holes compared to g series 6 bolt flywheel.

i know about the 1.6 baleno setup but they are not so easy to come by here.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/