TeamSwift

Home of the Suzuki mini-compacts ! Your Home for all things Suzuki Swift, Geo Metro, Holden Barina, Chevy Sprint, Pontiac Firefly, and Suzuki Cultus. TeamSwift is a technical performance oriented community!
It is currently Mon Oct 23, 2017 5:41 am

Underbody braces, turbos and more!

All times are UTC - 5 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sat Dec 22, 2007 3:21 am 
Offline

Joined: Wed Nov 23, 2005 5:25 pm
Posts: 232
Location: Derbyshire
I found out that the two centre inlets on the Mikuni Side Draft carbs are slightly further apart than the standard Suzuki Swift GTi manifold, the gap where the throttle linkage goes. So you cant get all four carb inlets to have a direct straight path to the manifold venturi's. When i cut the inlet manifold in half there was actually a gap between the two halfs after fastening the silicone hoses up. Unless this is because i`m using a Suzuki RD inlet manifold , maybe it isn`t as wide as the standard GTi manifold?

_________________
2000 Suzuki Swift GTi (MK2 1991 Engine)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group